Anyone who has an orchard or garden knows how frustrating it is to work day in and day out only to find that deer have eaten your lettuce, trampled your tomatoes, pulled up turnips and carrots, ruined your flower beds, ripped the leaves off your young apple trees, or eaten the fruits right off the trees.
And anyone who has put up deer fencing knows how expensive that can be: I have an orchard and a 10 foot wire deer fence. For many people that’s just not practical, so here is a cheap but effective deer fence.
Those that have tried it have had very good results. You will need:
● Fence posts, T-posts, or other types of stakes
● Clear 30-lb. monofilament fishing line
● 4- to 6-inch diameter PVC pipe
Place the fence posts at 15- to 20-foot intervals around the perimeter of your orchard, garden, or flower beds. Tie the 30-lb. monofilament fishing line around your first fence post at 12 to 18 inches up from the ground. Go to your next post and pull the line fairly tight but not so tight that it has no give. Wrap the line around the post 3 or 4 times and continue on to your next post until you have gone around the whole perimeter of the area you’re fencing. Then go up another 12-18 inches with another strand and continue this until you get to the top of the post. The higher you can go up on your posts, the better results you will have.
When you get to the end where your gate would be and where the first post you started from is located, take a 4- to 6-inch diameter PVC pipe or whatever diameter you would need for your post to fit into.
Cut the PVC pipe 12 to 18 inches, dig a hole 2 to 3 inches from the first post that’s in the ground. Put the PVC pipe into the ground and leave around an inch sticking up above the soil line. Leaving an inch of the PVC pipe sticking above the soil line prevents soil from falling back into the pipe. Remove the soil that’s in the PVC pipe and put your final post into the pipe. This final post will act as the gate. Put the final post either in or out of the pipe when you need to close or open the gate.
To hold the top two posts together, just take some type of “O” ring that would fit over the two posts or use some type of latch to hold them in place.
Once your fencing is done and a deer comes around in the daytime or the middle of the night, it cannot see the clear 30-lb. test line. When they brush up against it, they can feel it and know the something is there, yet they can’t see it. The deer have no idea how high they need to jump to get over the obstacle they have just walked into and they will stay away from the area.
It’s important to use only 30-lb. test line; anything lower than that and the deer have a tendency to break the line when they brush up or lean against it, and anything over that, they can see. This is also why you don’t want to use any colored or braided line; it’s easier for the deer to see it.
Another very important tip: Do not put any warning flags or signs on the line. This will only tell the deer how high they would need to jump to get over the fence.
It should appear that all you can see are the posts with nothing between them or hardly seeing the line at all.